96-02 4Runner Alpha Bumper - DIY Kit

Info to know before you order: THIS IS A DIY (DO IT YOURSELF) KIT! It is shipped as multiple pieces and the customer welds it themselves. This is NOT A WINCH BUMPER. There is no room or mounting points for a winch inside the bumper. Any grille guard tubing will not be pre coped and will be slightly oversized. Full hoops are not available as the bumper is extremely tight-fitting to the front end and there is no room to mount the headlight hoops without hitting the fenders. In order to get the tightest fitment and strongest mounting design possible, there is some modification required. You will have to trim 2 inches off the front of the frame rails on the vehicle. This will not reduce the integrity of the frame. After cutting, clean and coat the cut area with some spray paint to prevent any rust issues. The bumper will not currently work with body lifts! Versions for body lifts will be available in the future. The bumper parts are uncoated raw steel. There may be small imperfections on the surfaces of the parts, such as small areas of surface rust or shallow scratches caused during the manufacturing or shipping processes. A little about the bumper: Most DIY bumper kits include dozens of small flat pieces of metal and require hours of lining up, welding, and grinding, which can be incredibly frustrating and time-consuming. We set out to design a DIY bumper kit unlike any other. All the parts are laser cut and press bent with slotted and tabbed edges. This means it requires a fraction of the welding and grinding compared to other kits. With the built-in tabs, the bumper pieces line up perfectly and don't require you to consistently be checking measurements. You don’t even need to have the bumper on the 4runner to be able to tack it together. We wanted to be able to offer the best fitment possible so we took our design a step above all the other fabrication companies out there and had the front of the truck laser-scanned! This allows us to model the bumper within our cad programs using a virtual representation of the truck that is accurate to within .005 inches! The frame mounting plate, inner support plate, skid support plate, and inner and outer wings are all 3/16" HRPO steel. The inner main vertical plates are 1/4” thick steel. The wing support brackets with incorporated shackle mounts are 3/8" steel with 1.5 OD .250 wall DOM tubing welded in. All other sheet metal parts are made of 11 gauge HRPO steel. All tubing is 1.75 OD 11 gauge ERW steel. The bumper was modeled around an Extreme LED 22" X6 10W lightbar. There is a Chinese version of the same bar available on amazon for a third of the price. Fog light holes are 2.5" projected straight forward, so they're actually a slight oval. 22" Extreme LED Lightbar: https://www.srqfabrications.com/product/x6-10w-ser... We realized that these bumpers are going to be mounted on 20ish-year-old vehicles and the chances of each and every one of them having a perfect frame with no previous front end damage are slim. So in order to offer the best fitment possible, we made all the mounting points slightly oversized. This will give you a little adjustability when mounting. Depending on how far you need to adjust you will possibly need to use washers as shims between the bumper and the frame. New bolts and washers are included. Weighs roughly 80 lbs without lights. Any grille guard tubing will add to this. Lead time: 2-3 Week This is only an estimate and may occasionally be slightly longer or shorter depending on the workload and availability of parts. This does not include time in transit after shipment. Please contact us for updates on your order. Shipping: $100 FLAT RATE to the lower 48. Free local pickup in Sarasota, FL is also available. If you are outside the lower 48 please contact for a shipping quote.