7075 Double Shear Front Knuckles | Can-Am X3

Can-Am X3 Front Double Shear Knuckles The 7075 X3 Front Double Shear Capped Knuckle Set is the strongest front knuckle upgrade available for the Can-Am Maverick X3. Designed, tested, and race-proven by ZRP, this kit eliminates the factory weak points that cause OEM knuckles to bend, crack, or fail under aggressive riding and racing conditions. CNC-machined from USA-made 7075 billet aluminum, these front knuckles are over 5X stronger than stock, with lab-tested strength ratings of 86,000 lbs, compared to approximately 17,000 lbs for OEM knuckles. The double shear capped design adds critical reinforcement against rock strikes and hard landings while dramatically increasing press-out resistance and structural rigidity. 💪 Extreme Strength Where X3s Fail Lab tested to 86,000 lbs Over 5X stronger than OEM Eliminates bending and cracking under load Built for desert racing, rock crawling, and high-speed abuse 🧱 7075 Billet Aluminum Construction CNC-machined from 7075-T6 billet aluminum Nearly 3X stronger than 6061 aluminum Precision-machined for perfect fitment Built to withstand extreme off-road punishment 🛡️ Double Shear Capped Design Reinforces critical load paths Increases resistance to rock impacts Adds press-out strength at the hub Significantly stronger than open knuckle designs 🔩 ARP Hardware & Precision Components Includes ARP bolts for maximum clamping force Anti-rotation locking caps prevent movement Threaded caps increase bearing retention strength Built for racing-level reliability ⚙️ Pre-Installed Wheel Bearings OEM wheel bearings pre-installed & torqued Reduces installation time Ensures proper bearing preload Ready to bolt on and ride 📦 What’s Included (Complete Set) Left & Right 7075 Double Shear Front Knuckles (4) ARP Bolts (8) 7/8” Uniball Misalignment Spacers (4) Anti-Rotate Locking Caps with Screws LH & RH Threaded Caps Threaded Cap Removal / Installation Tool Pre-Installed & Torqued OEM Wheel Bearings ⚠️ Fitment & Installation Notes (READ BEFORE INSTALL) Requires 7/8” uniball or rod end Will NOT work with standard ball joint A-arms Torque ARP bolts to 53 ft-lbs Minimum: 48 ft-lbs Maximum: 60 ft-lbs Axles must be torqued to at least 180 ft-lbs Applies to all axle and hub brands 🏁 Why Choose ZRP? Race-proven in extreme off-road environments CNC-machined in the USA Designed, tested, and manufactured in-house Trusted by racers and aggressive riders worldwide ⏳ Availability Limited stock available Built in small production runs Order now before the next batch sells out