Crimping Tool Certification Services

CRIMPING CERTIFICATION SERVICE Our Miromar/FerrulesDirect crimping tools are factory calibrated for exact functionality and immediate use. This calibration and certification procedure is an additional test of the crimping performance of the tool using Miromar/FerrulesDirect UL certified ferrules, as well as terminals.  PLEASE NOTE THE FOLLOWING: SERVICE IS ONLY AVAILABLE FOR TOOLS PURCHASED ON OUR WEBSITE. OUR TESTING RANGE IS 28 TO 1 AWG ONLY. CERTIFICATION SPECIFICS: One terminal and one corresponding wire for each size covered by the tool is collected for the operation. Each wire is stripped according to specifications. Wire is inserted in corresponding terminal and crimped. Crimped terminal is loaded on testing device. Crimped terminal is pulled until it reaches its target value, then kept at that value for 60 seconds. Testing Device pulls crimped terminal until wire snaps off the terminal. Resulting value is recorded in Ferrules Direct database and a suitable Calibration Certificate is issued to customer. This Calibration Certificate includes: Date of Test Tool’s Model # Tool’s Serial Number Specifications tool was tested against Table showing test results Signature of testing technician Note: Wherever possible, Ferrules Direct will provide the necessary wires and terminals used to perform the calibration testing. If either wires or terminals are not available to Ferrules Direct, it will then become the customer’s responsibility to supply the items necessary for the testing.