3 Head Polisher

Grind and polish concrete faster and flatter with three heads working at once. The Z Counterform Three Head Concrete Polisher puts three 4" heads and a 1500W motor to work on every pass, so you cover more surface in less time and keep your countertops, floors and slabs flat and consistent. Use it wet or dry, keep the mess contained with the full bristle shroud, and polish right up to the wall when you need to. Why You'll Love It Three heads, more coverage Three 4" heads spread the load across a wider footprint than a single pad polisher. You get a flatter, more even finish with less chance of dishing or gouging, and you get through big jobs in a fraction of the time. Variable speed dial Turn the dial to set your speed anywhere from 2500 to 4800 RPM. Slow it down when you want more control, then crank it up when you're ready to move fast. You pick the speed that matches the job and the pad you're running. Bristle shroud keeps dust and water under control The full bristle shroud does an excellent job of stopping dust in its tracks. When you're polishing wet, it also keeps the water from flinging all over your shop, your walls and you. Your slurry stays on the work surface where it belongs. Use it wet or dry Going wet? Hook a standard garden hose up to the included water feed and you're ready to go. Going dry? Simply remove the water attachment and connect your shop vac to the port on the back of the shroud for dust collection. Polish right up against the wall Remove one side of the shroud and you can run the polisher tight against a wall or backsplash. No more leaving an unfinished strip along the edge. Ready to work out of the box It comes with grinding cup wheels, diamond polishing pads, sandpaper, foam backer pads and spare motor brushes so you can start grinding and polishing the day it arrives. Specifications Power 1500W Voltage 120V / 60Hz Speed Variable speed dial, 2500 to 4800 RPM Polishing Heads Three 4" heads Operation Wet or dry Water Connection 3/4" garden hose thread Dust Collection Vacuum port on rear of shroud Insulation Double insulated What's in the Box Three head wet/dry concrete polisher Water/dust shroud with adapters 3 x 4" grinding cup wheels 3 x 4" foam backer pads 3 x 150 grit 4" diamond polishing pads 6 x sandpaper discs 2 x replacement motor brushes 1 x hex key and shaft wrench Safety tip: When polishing wet, always plug into a GFCI protected outlet and wear rubber gloves to reduce the risk of electric shock. Product Warranty: This product has a 90 day limited warranty. Liability under this warranty is limited to the replacement of the product as purchased, if found to be defective upon inspection by Concrete Countertop Solutions within 90 days of purchase.