3D Speed

3D SPEED is an AIO (All In One) Correction Glaze, it works as a polish, sealant, and wax,  Speed works well, is quick application, and easy to work with. In fact, it’s the most versatile AIO on the market today. 3D SPEED can be used with any type of machine, any type of pad and is the most effective AIO on the market if you choose to work by hand. All-In-One car scratch remover, swirl correction and wax sealant Premium car polish and wax all in one bottle Restores paint color, depth and gloss while also adding a layer of protection For best results, apply with a Dual Action or Random Orbital Polisher Directions: IMPORTANT: Always work on a clean, cool surface in the shade.  Car should already be washed and dried and if needed, use detailing clay first to remove any above surface bonded contaminants. By orbital polisher Step 1: Apply 4-5 nickel sized drops of 3D SPEED to the face of the pad. Step 2: Using a slow to medium speed, spread 3D SPEED out over a section of paint no larger than 2’x2’. Step 3: Turn polisher to high speed and begin working the 3D SPEED over the panel using an overlapping, crosshatch pattern for 2-4 minutes. Step 4: Move onto a new section of paint and repeat the above process until an entire panel has been worked with 3D SPEED. Step 5:  After the wax has dried to a haze, normally around 15 to 20 minutes, remove the wax beginning with the panel where you first applied the wax and then following your path-of-travel, gently and carefully remove the wax using a clean, soft microfiber towels.  Turn the towel over or fold to a clean side often.  For best results, switch to a clean, dry microfiber towel often. By rotary polisher Step 1: Apply a circle of 3D SPEED around the middle of the face of the pad. Step 2: Using a slow to medium speed, spread 3D SPEED out over a section of paint no larger than 2’x2’. Step 3: Using a low to medium speed, begin working the 3D SPEED over the panel using an overlapping, crosshatch pattern for 2-4 minutes. Step 4: Move onto a new section of paint and repeat the above process until an entire panel has been worked with 3D SPEED. Step 5:  After the wax has dried to a haze, normally around 15 to 20 minutes, remove the wax beginning with the panel where you first applied the wax and then following your path-of-travel, gently and carefully remove the wax using a clean, soft microfiber towels.  Turn the towel over or fold to a clean side often.  For best results, switch to a clean, dry microfiber towel often.   SDS SHEET: 3D Speed