PLAY TUMBLER 480ml

SPECIFICATIONS 74 x H196 x W95 mm / 480 ml / approx. 295 g *Height of body (without lid) H180 mm DETAILS Actual capacity: 0.48L / Material: Stainless steel (powder coating) [Lid, drinking spout] Material: Polypropylene, silicone rubber / Heat-resistant temperature: 100℃ [Straw] Material: Polyethylene / Heat-resistant temperature: 70℃ / Cooling effect: 7℃ or less (6 hours) *Cooling effect refers to the temperature of water measured 6 hours after filling the product with cold water at room temperature of 20℃±2℃ and closing the lid when the water temperature reaches 4℃±1℃. *The cooling effect will increase if you fill the product with a small amount of cold water before pouring in the beverage and pre-cool it for about 1-2 minutes. / BPA-free / Made in China. This product is a beverage bottle for keeping drinks cold only. Cannot be used in microwave ovens. Cannot be used in dishwashers and dryers. Do not place near fire. Do not boil to clean. Do not drop or subject to strong impact as this may cause damage or leakage. Do not take your eyes off children when using the product. Please be careful of infants and young children playing with the product as this may result in accidental ingestion or injury. Do not put hot drinks in the bottle as this may cause burns. Do not put dry ice or carbonated drinks in the bottle as the container may expand and cause damage or injury. Use with the silicone gasket correctly attached. Do not put too much drink in the bottle as it may overflow when closing the lid. If the lid is not closed properly, the liquid inside may leak, so make sure it is securely closed. After closing the lid, turn the product upside down or sideways to check that there are no leaks. Do not drink while walking as this may cause injury in the event of a fall. When attaching the straw, insert it all the way in. When drinking with the straw attached, do not tilt the bottle too much as some drink may remain on the bottom corner. When putting it in a bag, keep it upright to prevent leakage. Do not shake or subject it to violent vibration as changes in internal pressure may cause the beverage to leak from the tip of the spout. Do not leave it in a car or other places where it may become hot. Do not put milk or other perishable items in it. Do not leave it for long with something inside, as this may cause rust or the beverage to spoil. To prevent rust on the stainless steel, remove any dirt and moisture as soon as possible, dry thoroughly, and store away from other metals. Do not leave it in water as this may cause rust or damage. Do not use cleansers or scrubbing pads when cleaning. Do not remove the drinking spout frequently as the resin will wear down and come off easily. If you are concerned about dirt around the drinking spout, remove it by turning it on its side and wash it. When attaching, push in the protrusions at the base one side at a time. Do not remove the silicone part under the spout when washing or soaking the cap, as water may get inside the cap. Do not use chlorine bleach as it may cause rust. If rust-like spots appear inside the container, add lukewarm water and about 10% citric acid, wait 2-3 hours, wash with a soft sponge, and rinse thoroughly. User's Manual https://cdn.shopify.com/s/files/1/0093/4785/8510/files/KINTO_PT480ml.pdf?v=1737018124