TO GO TUMBLER 480ml with straw

SPECIFICATIONS W3.4×H8.5in/480ml (16.2 fl oz)/Approx.9.5oz *Height of the body (without lid): H5.7in CARE INSTRUCTIONS   Capacity: 0.48L (16.2 fl oz)/Materials: Stainless steel, PCT resin, Silicone rubber/Dishwasher safe/BPA-Free/Made in China/Heat Retention: 172.4°F or higher (1 hour)/Cold Retention: 41°F or lower (1 hour). Heat retention is measured by filling the product with boiling water at 203°F±1.8°F at a room temperature of 68°F±3.6°F, closing the lid, and measuring the water temperature after 1 hour. Cold retention is measured by filling the product with cold water at 39.2°F±1.8°F at a room temperature of 68°F±3.6°F, closing the lid, and measuring the water temperature after 1 hour. Pre-warming (or pre-cooling) the bottle with a small amount of hot (or cold) water for 1–2 minutes before use improves thermal performance. Do not use in microwave or oven. Do not place near fire. When using a dishwasher, avoid tightly packing and place the product on the top rack. Keep out of reach of infants. Do not drop or subject to strong impact as it may cause damage or leakage. Do not overfill as contents may leak or cause the lid to rise due to internal pressure. If the lid is not properly closed, the contents may leak—ensure it is securely fastened. Even with the lid on, the bottle is not fully sealed—do not carry it on its side. Do not carry in bags while filled with beverages. Do not carry by the lid as the container may detach and cause damage. To open the lid, lift it while sliding slightly to one side. Be cautious when opening the lid while filled, as it may spill and cause burns. Due to its double-wall construction, the exterior may not feel hot even when the contents are—take care to avoid burns. Do not leave in high-temperature environments such as inside cars. Do not leave beverages inside for extended periods as it may cause rust or spoilage. Do not use with citrus-based drinks as terpenes from the peel may degrade the lid or straw. Fine lines on the lid may be visible but are not cracks—they occur during molding. To prevent rust, clean and dry thoroughly after use and avoid contact with other metals during storage. Do not leave submerged in water. Do not use abrasive cleansers or scrubbing tools. Do not use chlorine bleach as it may cause rust. If rust-like spots appear inside, fill with warm water and approx. 10% citric acid, let sit for 2–3 hours, clean with a soft sponge, and rinse thoroughly. Instruction Manual https://cdn.shopify.com/s/files/1/0093/4785/8510/files/KINTO_TGT480ml.pdf?v=1744697122