19" HP t630 Thin Client Rack Mount - 2U

This is a 19 inch rack mount for the HP t630 thin client. It lays the t630 flat and brings it into a standard 19 inch rack, with the rear I/O facing out so your display, network and serial connections stay reachable. Good for homelabs and network closets where a repurposed thin client is doing real work rather than sitting under a desk. **Compatible with:** HP t630 Thin Client, the 240 x 220 x 42 mm chassis measured without its stand. It does not fit the t730 or t620 PLUS, which share the same footprint but are a much thicker slab, and it does not fit the smaller t530, t540 or Elite t655. ⚠️ Important: Take the stand off before mounting. The large side panels of the t630 are vent grids, so this mount uses an open vented tray to keep that airflow clear. Leave it some breathing room in the rack. You get the printed mount, which assembles from a center tray and two slide-on rack ears. Rack mounting screws are not included, so use whatever your rack takes. I 3D print this mount in PETG, which handles the warmth of a thin client running all day better than PLA. 💬 For any custom design requests please message me.