15 ft Stationary Scaffold Tower Bundle

Built to work season after season, this non-rolling tower delivers a wide 7′ deck and rust-fighting protection everywhere it matters. You’re getting a three-section ladder stack with 7′ bracing and a full deck of severe-duty 7′ aluminum-plywood walkboards. Braces and hardware are galvanized inside and out to help block rust in the tube interiors, and the ladder frames wear a tough powder-coat that shrugs off everyday knocks. Base plates keep the tower fixed, while the 5′ × 7′ BreakDown Guardrail System helps you work safe at height. What’s working for you Severe-Duty 7′ Walkboards: Aluminum side rails + exterior-grade plywood deck feel planted underfoot; the integrated wind-latch helps keep boards seated. Three boards span the bay for a full 7′ platform. 5′ × 7′ BreakDown Guardrail System: Top/mid rails and posts go together fast and break down for transport—simple, commonsense protection when you’re working at height. Base Plates: Provide a fixed, non-rolling footprint that spreads load and reduces shimmy on firm, level surfaces. Climb-Friendly Frames: Familiar ladder-style access between levels; durable finish stands up to jobsite life. Setup & Safety Tips At ~15 ft, go wider: Add Outriggers—even on stationary builds—especially if floors are uneven or slick. Guardrails on? Many jobsites also require Toeboards to help keep tools and materials from stepping off the edge. Thinking about rolling later? If you add casters, include a Grouser Bar to tie frames together for stability while you move. Key Features Full 7′ Deck: Three severe-duty walkboards deliver a broad, stable work surface. Rust Defense: Galvanized braces & hardware—tube interiors included—help extend service life. Planted Stability: Base plates keep your tower fixed and confident underfoot. Grows with You: Add height, outriggers, and toeboards as jobs demand—or convert to rolling with casters and a Grouser Bar. Important Notes For taller builds or uneven/slick floors, add Outriggers to widen the footprint. If you later add casters to this stationary tower, also add a Grouser Bar to tie frames together for rolling work. Some competitor braces aren’t coated internally. If there are no small vent holes near the brace ends, the interior may not be galvanized and can rust over time.