Printed Pattern Heat Transfer Vinyl - Stained Glass

Custom Pattern Heat Transfer Vinyl ** EasyPatterns now require the use of our TTD High Tack Mask sold separately** All the Variety Without the Extra Work! The pressure sensitive carrier allows for quick and simple weeding and releases easily with a hot peel after application. With a semi gloss finish and soft hand, Custom Patterns are the star of the show even when applied with a home iron! EasyPatterns Apply to: 100% cotton Poly/cotton blends 100% polyester Leather Lycra®/spandex CUTTER SETTINGS: Cricut: Blade: Standard Setting: Iron On Silhouette Cameo: Blade: Standard, 3 Material: Heat Transfer, Smooth Speed: 8 Force: 6 Scan N Cut: Blade: Standard, 2 Cut Speed: 1 Cut Pressure: 1 Roland GS/GX-24: Blade: 45° Gram Force: 80-90 Offset: .250 Speed: 25-50 cm/s Graphtec: Blade: 45° Gram Force: 9 Tool: CB09U+0 Speed: 25 cm/s MH, SC2, LP3, and Titan 1: Blade: 45°/60° Gram Force: 80-85 Speed: 300mm/s *Blade Advancing Varies Titan 2 & 3: Blade: 45°/60° Gram Force: 60-65 Speed: 300mm/s *Blade Advancing Varies Visit our Facebook Page at: Vinyl and Tulle Supply If you have any questions, call our customer service line at: 352-366-8840 Application instructions (home iron) • Set iron dial between Cotton and Linen • Cover design with Kraft paper or non-stick cover sheet • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) • Press each section of design for 15 seconds • If areas of design lift after application, replace cover sheet and re-press for 10 seconds • Peel carrier hot or cold Application Instructions (heat press) • Cut material – don’t mirror! • Weed excess material • Mask with TTD High Tack Mask • Preheat garment for 2-3 seconds • Apply design at 305°F/150°C • Use medium pressure for 10-15 seconds • Peel carrier hot or cold • Cover and reheat for 2-3 seconds