10mm Stacked Band Pin (Pair)

Free Shipping In addition to our heavy duty Short Stack Weight Pins, we are now offering the best solution to adding more than just additional weight or chains. With the 10mm Stacked Band Pin, you can utilize bands on your weight stacks to add a whole new level of resistance training. Complete with 21lbs of magnet pull to ensure a tight and secure fit on your weight stacks.  With our smaller rod at ~1.5", you can insert each band pin into the desired pin hole on both sides of the stack without them interfering with the guide rod inside. This allows you to move the stack freely from a lower position and utilize the heavier weight stack below to keep the bands in place. Don't have access to the back side of the weight stack? That's ok! Place one band pin above your selector pin and leverage the bottom band pin to get your resistance going. Not only can you utilize these band pins for the resistance of bands, but you can double them up as adder pins. Weighing in a 2.5lbs each, utilize these pins for those pesky plateaus and make incremental gains the right way. They can even accommodate additional weight* up to approximately 20lbs.  Sold in pairs. Bare Steel Products Bare Steel is susceptible to rust, so if you have any concern of rusting in your training environment, we recommend you upgrade to Cerakote or Hard Chrome. In the long run, it’s a worthwhile investment. Bare Steel products cannot be returned due to rust. While we take every step to ensure a Bare Steel item arrives in mint condition, the elements may still play a role in light rust formation. Most of the time, this is simple surface/flash rust that can be removed with a light wool padding and oil/silicone spray. We will return items based on manufacturing defects or reasons stated in the return policy. Specs and Features SOLD IN PAIRS Hard Chrome includes both pin and rod Barbell Sleeve: 3″ long with 2″ diameter, fitting Olympic weights Six-Shooter magnets with 21 lbs of pull Rod Diameter: 10mm Rod Length: ~1.5" to allow use on both sides of a weight stack Microloading makes a great adder weight for physical therapy and medical rehabilitation  Weight: 2.5lbs *Max Weight: 25lbs depending on the type of weight stack you have Made in USA 100% USA Steel Bare Steel pins ship in 3-5 business days Cerakote, Hard Chrome and other custom modifications, see our SHIPPING POLICY Worldwide shipping available* *international orders may be subject to import fees For California Residents: ⚠️ WARNING: Cancer and Reproductive Harm — www.P65Warnings.ca.gov Custom Logo Decal We are now offering custom logo decals for your Stacked Weight Pin. The upgrade comes with 10 decals. Here’s how the process works: Purchase your pin and add on the custom decal Send us an email to info@baresteelequipment.com with your logo. Preferred formats are .png, .ai, .pdf, .svg or .eps We will send back a draft for you to approve NOTE: all artwork MUST contain the Bare Steel Equipment text and/or skull design Approved logos take 2-3 weeks to arrive Laser Engraving We are now offering laser engraving on our pins. This eliminates the need for a front decal and will feature the Bare Steel Equipment Skull logo and the text along either the side of the pin or along the rod. Because of the requirement for hanging during the drying phase for Cerakote, a small hole will be drilled at the end of the pin rod to accommodate this. This will not affect the use of the pin. Please allow 3-5 weeks for completion. UPS Ground Shipping Time CAUTION: The Stacked Weight Pin is intended to be used as an adder weight or for band pin use attachment only.  It is important to check and verify the weight capabilities of your cable machines prior to use. Failure to do so may result in serious injury.  *NOTE: It is important to measure your selector pin or stack hole for the most accurate fit. A digital caliper will provide the most precise fit and are inexpensive and very convenient to have. You can find them on Amazon. If unsure of fit, measure first.