10" X 3/4" Hydrobat (Requires Adapter)

10" X 3/4" HYDROBAT with 6" Bat pin spacing. (REQUIRES ADAPTER for fit 10" pin out) NOTE: 12% Double Box Packing fee is added to all Hydrobat orders shipping UPS. Does not apply to in store pickup. 20" and 24" Hydrobats cannot ship UPS : those two sizes are available for in-store pickup and freight deliveries only 10 times stronger than pottery plaster bats! The Hydro-Bat is made of Hydro-Stone, a USG product containing cement and crystalline silica, that is 8 to 10 times stronger then pottery plaster. The surface is scratch resistant yet absorbs water like plaster eliminating the need to cut your pieces off the bat with a wire. The Hydro-Bat was designed to fit on wheel heads that have bat pins spaced 10 inches apart on center. The hard rubber grommets cast into the underside of each Hydro-Bat will not swell or change shape and are sized to fit over a 3/8 diameter bat pin head. Due to their smaller diameter, the grommets under the 8.5 and 10" Hydro-Bat's are spaced 6" apart and require the HBA Adapter to convert standard 10 inch pins to 6 inches. This adapter is made of sturdy polyethelene plastic and fits snuggly over the 10" bat pins on your wheel head. It has two upfacing 3/8" diameter bat pins fused in at 6” apart. The 8.5"& 10" Hydro-Bats fit onto these pins. Similarly, the 6" Mini Hydro-Bat has grommets spaced 4" apart and requires the HB6A Adapter to convert the standard 10" pins to 4". (If desired, these adapters can be used as templates to permanently drill 4" or 6" holes into . If you have a wheel head with pins positioned at 9" apart we make Adapter HB9A which will allow you to use our bats. If you don't have bat pins in your wheel, no problem, our product works great with a bat gripper or grabber which allows you to attach any kind of bat to a wheel head. Custom adapters can be made for any size wheel head or pin configuration.