1/2" x 4 -3/4" Crossover Bolt

No hammer required to place. Can be placed by simply inseting into your prepared hole with a proper bonding agent. If you use a hammer, we we recommend a min of 16oz, hard plastic deadblow or Stainless Steel hammer. UIAA GC corrosion resistant certified!   1/4" Crossed Wires Drill Hole Dia: 1/2" Length approx. 4-3/4" (120mm), * - (Length may vary +/- 1/8") 316L Stainless Steel. Made in the USA! Strength:        Placed without hammer:        Axial, (straight out pull): 35+ kN        Raidial, (straight down pull): 48+ kN       Wedge system set with hammer:        Axial, (straight out pull): 47+ kN        Raidial, (straight down pull): 48-50+ kN Visually low impact  Constricted fit: The Patent Pending Crossover wedging system provides a mechanical advantage that locks the anchor in place while the bonding agent cures. This is helpful on over-hanging routes! Device usable by only a single connected user: 1P